No-Wrench Screw Anchors may be installed by hand or machine. The forged Triple Eye on the rod has a large opening to admit a turning bar for screwing the anchor down. The eye will also fit into an adapter available from most hole-boring machine manufacturers so the anchor may be power-installed. The entire anchor is hot-dip galvanized for long resistance to rust. Hot Dip Galvanized per ASTM A123.
No-Wrench Screw Anchors can be installed to a greater depth to reach a firmer soil by using an extension rod.
Note: If hand installed, holding capacity may be reduced by as much as 10% to 20%. Capacity ratings apply to properly installed anchors only. Failure to install within 5 degrees of alignment with the guy load will significantly lower strength.
