Fiber Optic Cable Blowers
Fiber Optic Cable Blower
The Condux Gulfstream 400 Lightweight Deluxe Fiber Optic Cable Blower installs up to 300 feet of fiber optic cable per minute. The cable travels at the same speed as the air. Blowing cable minimizes the stress placed on the cable during the installation process. Because the cable blower provides both pulling and pushing force, the stress is balanced.
The Condux Fiber Optic Cable Blower is designed for the installation of fiber optic cables with diameters from 0.23" to 1.13" into innerduct from 0.98" OD to 2.35" OD. Correct seals, feed tube, and venturi must be determined for the cable being installed.
Gulf Stream Micro Fiber Blowers
The Mini-Blower/Pusher from Condux is the lightweight, portable solution for easy installation of micro fiber and traditional fiber optic cable. The compact unit is ideally suited for your most difficult job sites and "last mile" fiber installations. An updated design has made operation easier than ever.
The Mini-Blower/Pusher is designed for the installation of fiber optic cables with diameters from 0.23" (5.8mm) to 0.50" (12.7mm) into micro duct 10mm to 18mm or traditional duct from 0.50" (12.7mm) to 1.5" (38.1mm).
Hand-held Micro Fiber Blower
The Condux Hand-Held Micro Fiber Blower is an air assisted cable installation device designed to make premise and drop fiber optic cable installations a breeze. It is ideal for smaller cables and shorter distances.
The cable must have 60% or less fill ratio inside the duct in order for the hand-held blower to be effective. If you have a larger cable with increased fill ratio, or you are installing over longer distances, the Mini-Blower/Pusher is recommended.
*In 2011, Condux changed the part number of this unit from 08764000 to 08081315. The only changes made were to help the Hand Held Blower integrate with the Pusher unit. All other kits and attachments for the Hand-held blower prior to 2011 are compatible.