Track Cleaning and Tightening
- Inspect track before and after each use.
- Clean after each use, or when necessary. Remove the top assembly to clean thoroughly by:
- Remove top capscrew with a 3 mm allen wrench and the flat washer on clamp adjustment screw. This will allow for the top track assembly to be unscrewed off the blower with the clamp adjustment.
- Pressure wash if necessary
Replacement of the Drive Belt
The drive belt needs to be replaced when the machine is unable to tractor drive the specified range of cable diameters. Only genuine spares should be used otherwise the machine may be unsafe and void warranty.
- Remove the 2 capscrews which hold the sled in place with a 3 mm T-handled allen wrench. This should allow the sled to rotate up.
- Remove the pivot shaft with an 8 mm allen wrench.
- On the bottom drive, remove the 3 capscrews from the prox cover with a 2 mm allen wrench.
- The bearing cap can be removed from both the top and bottom assembly using a 5 mm allen wrench.
- At this point, the drive pulley can be removed straight out the same hole as the bearing cap and the belt can be removed. This sequence is reversed for the reassembly of the new belt with a key note, the dampening bushing must be rotated back to the smaller lobe position on the pivot shaft.